Manualshelf

Technical Manual

ManualsBrandsNapco Security Technologies ManualsComputers & AccessoriesThe Hub is the central unit that forms the alarm panel. The Hub connects to a variety of wireless sensors that perform various sensor interfaces in the premises.
12345678910
10 All technical manuals are available in PDF format at tech.napcosecurity.com Napco iSecure Security System
1. Install the Go-Anywhere Hub
Place your Go-Anywhere Hub in a protected central location inside
the premises, preferably in an elevated area (not on the floor) and near
a standard un-switched / uninterruptable 120VAC electrical outlet.
Place on a shelf, desk or wall mount
Avoid proximity to electrical junction boxes, wireless telephones,
wireless routers and transmitters (including baby monitors)
Do not place in attics, utility, AV or computer closets
Basement installation is NOT preferred
Locations with proper ventilation and climate control are preferred
WALL MOUNTING
1. Mark the four mounting hardware locations. Use a level to en-
sure horizontal mounting.
2. Using #8 screws appropriate for the mounting surface, install the
top two screws into mounting surface. Note: When mounting to
hollow drywall or similar surface, we recommend using wall an-
chors or similar hardware appropriate for the installation.
3. Separate the Go-Anywhere Hub housing: With a flat head screwdriver, push in the two tabs at the bottom
to unhook, then carefully separate the two parts of the housing .
4. Hang the rear housing by placing the top two keyhole-shaped holes over the two screws installed in step 2.
Use the pre-installed Hanger Clip (see image below) to hang the front cover.
5. Install the two bottom screws (use #8 screws appropriate for the mounting surface) and tighten the two top
screws. Do not over-tighten (to prevent the housing from distorting).
6. Power up using an un-switched 120VAC outlet (power wires can be snaked through the wall). Install and
connect the 4AH or 5AH battery (not supplied), observing polarity; secure battery with Velcro strap.
7. Remove the plastic protective film from the face of the Go-Anywhere Hub.
STAND-ALONE INSTALLATIONS
If placing on a shelf or desk, install the supplied rubber feet on the bottom of the Go-Anywhere Hub
Run the power adapter wiring to the nearest un-switched 120VAC outlet and plug in
Install and connect the 4AH or 5AH battery (not supplied),
observing polarity; secure battery with Velcro strap
Remove the plastic protective film from the face of the Go
-Anywhere Hub.
Go-Anywhere Hub
Use Hanger Clip to simplify wall mounting and wiring
Voice Prompt Volume
To control the Hub voice prompt volume, press the
following keys at any keypad in the system:
On/Off = 1 + ENTER
Louder = 2 + ENTER
Softer = 3 + ENTER