Technical Manual

74 All technical manuals are available in PDF format at tech.napcosecurity.com Napco iSecure Security System
 ISEC-HEAT Wireless Heat Detector with Rate
of Rise: A high-quality 135°F (57°C) fixed tem-
perature detector with Rate of Rise and built-in
supervised digitally-coded radio transmitter. It is
compatible with Napco's iSecure RECV series
supervised receivers that monitor alarms, re-
stores, low battery, tamper and status.
 ISEC-KEYFOB 4-Button Pendant/Keychain
Transmitter: This multifunction transmitter
serves as an Area arm / disarm device with two
auxiliary functions, and may be used as a police
panic and/or auxiliary emergency transmitter.
 ISEC-WL-MODULE Wireless 8-Zone Takeover
Module: Designed to make use of the wiring
and power supply of an existing wired security
system, the ISEC-WL-MODULE is designed to
convert 8 hardwired zones into eight supervised
wireless burglary, 4-wire Fire or CO zones, thus
simplifying installation, including the ability to
work with existing 12 volt power supplies. The
module is commonly mounted next to the existing
control panel, in close proximity to the existing
hardwired zone connections. Wireless frequency
is 900MHz.
 ISEC-MOTION Passive Infrared Motion Sen-
sor: An advanced PIR sensor designed for
use with Napco's iSecure RECV series wireless
receivers. The ISEC-MOTION is powered by
two supplied 3-volt lithium batteries (estimated
battery life 3 years). When battery voltage drops
below normal, a low-battery report will be sent to
the receiver.
 ISEC-PANIC Single Button Waterproof Panic:
A single-function pendant/keychain transmitter
that serves as an emergency device for use as a
police panic and/or auxiliary emergency transmit-
ter. Two replaceable 1.5V silver oxide cells pow-
er this portable transmitter (it includes a flashing
LED to warn when low batteries require replace-
ment). To operate, simply press the button mo-
mentarily.
 ISEC-WL-SIREN Wireless Siren: Output pro-
vides 85dBA sound level at 10 feet, supports Si-
ren, Temporal Fire and CO alarm audible cadenc-
es, with optional bright LED strobe. Operable
from 110VAC with battery backup, or by battery
power alone; mountable on flat wall or by AC out-
let plug; for indoor or outdoor operation. The iSe-
cure system can accommodate up to 4 wireless
sirens. Wireless frequency is 900MHz.
 ISEC-SMOKE Supervised Wireless Digital
Smoke Sensor: A high-quality photoelectric
smoke sensor with built-in supervised digitally-
coded radio transmitter. It is compatible with
Napco's iSecure RECV series supervised receiv-
ers that monitor alarms, restores, low battery,
tamper and status.
 Optional ISEC-WIFI Internet Module for backup
central station communication and notifications.
Supplied in KIT 3 (see above).
 Optional ISEC-ZWAVE Z-Wave Module for pro-
gramming/control of Z-Wave home automation
controls such as Z-Wave-enabled lights, outlets,
thermostats, garage door operators and door
locks.
Ordering Information (cont'd)