User's Manual

W415-0447 / B / 05.24.05

FIGURE 48

1. Unplug the cord from the junction box

2. Pull the the tab on the receiver lock forward.

3. Pull up on the receiver and disconnect the wires.

4. Install the new receiver (see schematic Pg.23).

1. Remove the

hearth strip.

2. Open the right

control door.

3. Remove the

switch plate by pull-

ing on the left side.

4. Remove the valve

housing by pulling on

the handle.

5. Lift up and set the

housing towards the

back of the fire

place.

REMOTE RECEIVER REMOVAL

REMOTE AND VALVE ACCESS

The valve on the Madison is piped with two flex connectors

(one inlet, one outlet).

It can be removed or pulled forward for service.

1. Remove the wing nut and pivot the valve out from the slot

at the bottom of the valve.

2. Slowly pull the valve through the control door careful not

to kink the gas lines or wires.

VALVE REMOVAL

FIGURE 46

FIGURE 47

The control area can be accessed either through the control

door or through the access door inside the firebox.

Follow the door removal instructions. Remove the right side

panel. Remove the four screws from the access door.

Note: A new gasket will be required, when re-installing

the door (see replacement parts).

CONTROL DOOR

INNER ACCESS DOOR