TERRACE AND PATIO HEATER USER INSTALLATION AND OPERATION GUIDE INDEX General and specifications ……………….11 Security and caution …………………….. 12, 13 Tools and accessories required ………… 13 Assembly instructions …………………… 14,15 & 16 Verifying the connections ……………….. 17 Warranty info Carefully read this guide and all safety information before assembling and setting up the heater THIS APPLIANCE IS APPROVED FOR OUTDOOR USE ONLY Napoleon Appliance Corporation 214 Bayview Dr.
READ SAFETY REQUIREMENTS BEFORE OPERATION 1. The installation must conform with local codes or in the absence of local codes, with either the National Fuel Gad Code, ANSI Z223.1, or CSA B149.1, Propane Installation Code. 2. This outdoor gas appliance is not intended to be installed in or on recreational vehicles and/or boats. 3. Maintain proper clearances from combustible construction top 45 CM, sides 60 CM. 4. Inspect the hose before each use of the outdoor gas appliance.
SAFETY RULES FOR OUTDOOR GAS APPLIANCE 1. LP-gas supply cylinder to be used must be constructed and marked in accordance with the specifications for LP-gas cylinders of the U.S. Department of Transportation(DOT) Cylinders, or Spheres and Tubes for the Transportation of Dangerous Goods, CAN/CSA-B339. 2. The gas supply piping and electrical supply (if applicable) shall be done in accordance with all local and applicable codes.
FOR YOUR SAFETY 1. If you smell gas : a. b. c. d. Close gas supply at cylinder valve. Extinguish all open flame Proceed to a leak test If bubbles are detected, retighten connections. If no leaks are detected, open gas valve at cylinder and verify if you smell gas. e. If you still smell gas, shut-off heater completely and gas valve at cylinder. Call the retailer where you purchased the heater or contact a gas appliance service center. 2.
PARTS LIST 1 2 3 4 5 6 7 8 9 Base Cylinder cover Ventilation opening Post Ignitor Gas control Burner assembly Flame screen Reflector TOOLS AND EQUIPMENT REQUIRED 10 and 13mm wrench, Philips screwdriver, medium blade Leak test solution: MIX 50/50 water and soap 1 Propane cylinder (not supplied), with QCC 1 valve ASSEMBLY INSTRUCTIONS A. Fix the 3 vertical supports to the base using the 3 bolts M8 x 15. B C Fasten post to the vertical supports with 6 bolts M6 X 35 and 6 nuts M6.
Before assembling the burner head on post, please fix the 3 supported brackets onto burner head for assembling reflector D Slide hose through bottom of post and connect to burner head. Then fasten burner on post with the 4 Philips mechanical screws M6x10mm. E Sectional reflector option ONLY Assemble the reflector pieces to the middle piece using the small washers and the acorn nuts.
G Install a full gas cylinder on the base. Connect the gas regulator hose to the QCC1 Cylinder valve by turning the knob clockwise manually. Do not use a tool, tighten firmly by hand. Replace cylinder cover. LEAK TEST Now that the heater is assembled, for your safety you must perform a leak test of all connections and hoses. Mix in a spray bottle equal parts of water and soap. 4. Ensure that the heater gas control knob is fully closed by turning completely clockwise 5. Open cylinder valve. 6.
CLEARANCES FROM COMBUSTIBLES Respect clearances as shown: o Sides of reflector : 60 cm o Above reflector : 45 cm OPERATION TO LIGHT: 1. 2. 3. 4. 5. From‘OFF’position, depress knob, turn 90° counterclockwise and hold. Press the igniter until flame is established. Release the knob and check that the flame stays lit. If the flame goes out, wait 5 minutes then repeat steps 1 & 2 above. For maximum temperature, turn knob fully counter– clockwise. TO TURN OFF: 1. Turn the knob clockwise to the stop position.
● If you cannot repair a leak, turn off gas supply at the cylinder valve and contact the retailer where you purchased the heater or a qualified technician. ● Do not alter or modify in any way. ● The installation of this appliance should be done by a certified gas technician in accordance with all local, building and municipal codes. ● Contact the manufacturer at 1 – 866 – 820 – 8686 for replacement parts.