Oven User Manual

10
www.napoleongrills.com
WARNING! Always wear protecve gloves and safety glasses when cleaning your grill.
WARNING! Turn o the gas at the source and disconnect the unit before servicing. To avoid the pos-
sibility of burns, maintenance should be done only when the grill is cool. A leak test must be performed
annually and whenever any component of the gas train is replaced or gas smell is present.
Maintenance Instrucons
We recommend this gas grill be thoroughly inspected and serviced annually by a qualied service person.
Combuson Air Adjustment: (This must be done by a qualied gas installer.) The air shuer is factory set and
should not need adjusng under normal condions. Under extreme eld condions, adjustments might be
required. When the air shuer is adjusted correctly the ames will be dark blue, pped with light blue and
occasionally yellow.
• With too lile air ow to the burner, the ames are lazy yellow and can produce soot.
• With too much air ow, the ames li erracally and can cause dicules when lighng.
Adjusng the air shuer:
1. Remove cooking grids and sear plates and leave lid open. You may have to open the door or remove the
top drawer (if equipped) to access the air-shuer screw located at the mouth of the burner. The back cover
must be removed for rear tube burner air shuer adjustment.
2. Loosen air-shuer lock screw and open or close air shuer as required. The normal opening sengs are:
Main Tube Burner Propane 1/4” (6mm) Rear Tube Burner Propane Full Open
Natural 1/8” (3mm) Natural 3/8” (10mm)
*Infra-Red burners have no air adjustment.
3. Light the burners and set to high. Visually inspect burner ames. When the shuers are set correctly, turn
burners o, ghten locking screws, and replace removed parts. Ensure that the insect screens are installed.
Tube Burners: The burner is made from heavy wall 304 stainless steel, but extreme heat and a corrosive envi-
ronment can cause surface corrosion to occur. This can be removed with a brass wire brush.
CAUTION! Beware of Spiders.
Spiders and insects are aracted to the smell of propane and natural gas. The burner is equipped with an in-
sect screen on the air shuer, which reduces the likelihood of insects building nests inside the burner but does
not enrely eliminate the problem. A nest or web can cause the burner to burn with a so yellow or orange
ame or cause a re (ashback) at the air shuer beneath the control panel. To clean the inside of the burner,
it must be removed from the gas grill: Remove the control panel by removing the two screws in the lower
corners of the panel. Disconnect the leads from the igniter modules and light switch. All other leads can be le
connected. Push the control panel upwards to remove. Loosen the manifold assembly and pull it forward and
out of the burner. Do not allow the manifold to hang from the aluminum supply tube. Remove the screw that
aaches the burner to the back wall, loosen but don’t remove the two screws holding the sear plate mount
on the back wall. Li out the sear plate mount. Slide the burner back and upwards to remove. Cleaning: Use a
exible venturi tube brush to clean the inside of the burner. Shake any loose debris from the burner through
Light Blue
Yellow Tipping
Dark Blue
Burner
Burner Port
Approximately
1/2” (13mm)