Installation Manual

Table Of Contents
W415-1463 / C / 10.19.17
24
EN
6.0 optional installation
Drywall dust will penetrate into the blower
bearings, causing irreparable damage.
Care must be taken to prevent drywall
dust from coming into contact with the
blower or its compartment. Any damage
resulting from this condition is not covered
by the warranty policy. Use of the blower
increases the output of heat.
Provisions have been made on this
appliance to install an optional blower
kit (EPT70) that comes complete with a
variable speed switch to turn the blower
ON/OFF, as well as adjusting the blower speed.
A. Ensure the thermal disc bracket is in the correct
position.
B. Remove the knock-out from the back of the appliance.
C. Install the blower and housing as shown using the 4
screws supplied.
D. Loosen the thermal disc bracket (2 screws) and slide
the bracket until the thermal disc is touching the rear of
the firebox and secure.
KNOCK-OUT
BLOWER
THERMAL DISC
BRACKET
SCREWS
2100 PEDESTAL
MODEL ILLUSTRATED
Check that the thermal
switch bracket is
positioned as illustrated.
THERMAL SWITCH BRACKET
6.1 blower kit installation
!
WARNING
RISK OF FIRE AND ELECTRICAL SHOCK.
TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.
USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH
THIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GAS
COMPONENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILL
VOID THE WARRANTY AND CERTIFICATION.
ENSURE THAT THE FAN’S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THE
APPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWER
CORD BENEATH THE APPLIANCE.
THE WIRE HARNESS PROVIDED IN THE BLOWER KIT IS A UNIVERSAL HARNESS. WHEN
INSTALLED, ENSURE THAT ANY EXCESS WIRE IS CONTAINED, PREVENTING IT FROM MAKING
CONTACT WITH MOVING OR HOT OBJECTS.
35.1
SPECIFIC BLOWER INSTALLATION
INSTRUCTIONS MUST BE ADDED HERE.
THIS TEMPLATE MUST BE USED WITH ANY
APPLIANCE THAT OFFERS THE BLOWER AS
AN OPTION OR COMES STANDARD WITH THE
APPLIANCE... AS PER THE STANDARD.