Installation Manual

34
W415-1285 / F / 12.21.16
EN
55.2
A. Nailing tabs are provided as part of the frames, as shown. To determine the fi nal
location and where to bend the nailing tabs you must fi rst determine the thickness
of your fi nishing material (i.e. drywall). This will determine the dimension from the
front edge of the corner post to the nailing tab. Once the nailing tab is in the desired
location, secure with a sheet metal screw*.
* Additional screws may be installed.
NAILING
TABS
5.7 NAILING TAB INSTALLATION
!
WARNING
RISK OF FIRE!
NEVER OBSTRUCT THE FRONT OPENING OF THE APPLIANCE.
THE FRONT OF THE APPLIANCE MUST BE FINISHED WITH ANY NON-COMBUSTIBLE MATERIALS
SUCH AS BRICK, MARBLE, GRANITE, ETC., PROVIDED THAT THESE MATERIALS DO NOT GO
BELOW THE SPECIFIED DIMENSION AS ILLUSTRATED.
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
REMOVED, CRACKED, BROKEN OR SCRATCHED.
FACING AND/OR FINISHING MATERIAL MUST NEVER OVERHANG INTO THE APPLIANCE OPENING.
THE GLASS DOOR ASSEMBLY IS DESIGNED TO PIVOT FORWARD WHEN RELIEVING EXCESS
PRESSURE THAT MIGHT OCCUR. FINISHING OR OTHER MATERIALS MUST NOT BE LOCATED IN
THE OPENING SURROUNDING THE DOOR AS THIS WILL INTERFERE WITH THE DOORS ABILITY
TO RELIEVE THE PRESSURE.
72.6
SAFETY SCREEN
SAFETY SCREEN
A barrier designed to reduce the risk of burns from the hot viewing glass is provided with the
appliance and shall be installed.
Before the glass door can be removed, the safety screen must be removed. Lift the safety screen up and pull
it out of the bottom retainer. Pull the safety screen down and out of the top retainer.
Reverse these steps to reinstall the safety screen. Ensure it is installed correctly.
6.0 FINISHING
6.1 MAIN SAFETY SCREEN REMOVAL / INSTALLATION
When using optional finishing accessories, the framing dimensions and finishing materials may differ from what
is outlined in the section below; refer to the leaflet instructions supplied in the accessory kit for specific framing
and finishing specifications.