Installation Manual

36
W415-1285 / F / 12.21.16
EN
!
WARNING
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
IF EQUIPPED WITH DOOR LATCHES THAT ARE PART OF A SAFETY RELIEF SYSTEM, THEY MUST BE
PROPERLY ENGAGED. DO NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRE OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
75.1A
!
WARNING
THE DOOR LATCHES ARE PART OF A SAFETY SYSTEM AND MUST BE PROPERLY ENGAGED. DO
NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRE OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
75.1
THIS WARNING FOR ELECTRICS ONLY:
A. Remove the safety screen, see "MAIN SAFETY SCREEN REMOVAL / INSTALLATION" section.
B. Loosen but do not remove the three securing screws from the top retainer and pull retainer away from
the appliance, refer to Figure 1.
C. There are two latches on the top of each door, refer to Figure 2. Using the tool provided, pull the latch
forward and upwards, out of the slot in the door, as shown. Ensure to keep one hand on the door
at all times, to prevent it from falling on the floor.
D. When both latches have been released, tilt the door forward and out of the bottom door retainer.
E. Reverse this process to install the door.
LATCHES
FIG. 1
FIG. 2
6.3 MAIN DOOR REMOVAL / INSTALLATION
IMPORTANT: Once latches are engaged,
test that the door is secure and will not
fall forward before letting go.