Installation Manual
Table Of Contents
- W415-1285_Fe
- 1.0 installation overview
- 2.0 introduction
- 3.0 venting
- 4.0 installation
- 5.0 framing
- 6.0 Finishing
- 6.1 main SAFETY SCREEN removal / installation
- 6.2 end SAFETY SCREEN removal / installation (bhd4p only)
- 6.3 MAIN door removal / installation
- 6.4 END DOOR REMOVAL / installation (bhd4p only)
- 6.5 control panel removal
- 6.6 hearth pad installation
- 6.7 log placement
- 6.8 glass media installation
- 6.9 logo placement
- 7.0 wiring diagram
- 8.0 operating instructions
- 9.0 Adjustment
- 10.0 MAINTENANCE
- 11.0 replacements
- 12.0 accessories
- 13.0 troubleshooting
- 14.0 warranty
- 15.0 SERVICE HISTORY
- W415-1285_Ff
- 1.0 vue d'ensemble de l'installation
- 2.0 introduction
- 3.0 éVACUATION
- 3.1 LONGUEURS DES CONDUITS D’ÉVACUATION ET COMPOSANTS
- 3.2 INSTALLATIONS TYPIQUES D'ÉVENTS
- 3.3 INSTALLATIONS PARTICULIÈRES D'ÉVENTS
- 3.4 convertir l'Évacuation de 5/8" À 4/7"
- 3.5 EMPLACEMENTS ET DÉGAGEMENTS MINIMAUX DE LA TERMINAISON
- 3.6 CHARTE D'APPLICATION DES ÉVACUATIONS
- 3.7 LÉGENDE
- 3.8 VALEURS DU COUDE EN LONGUEURS D'ÉVENT
- 3.9 TERMINAISON HORIZONTALE
- 3.10 TERMINAISON VERTICALE
- 4.0 installation
- 5.0 ossature
- 6.0 Finitions
- 6.1 RETRAIT de l'écran de protection PRINCIPAL et l'installation
- 6.2 RETRAIT de l'écran de protection fin et l'installation (SEULEMENT bhd4p)
- 6.3 installation / enlèvement de la porte PRINCIPALE
- 6.4 Enlèvement DE LA PORTE D'EXTRÉMITÉ / INSTALLATION (SEULEMENT bhd4p)
- 6.5 enlèvement de PANNEAU DE CONTRÔLE
- 6.6 INSTALLATION des bases de protection (bHD4ST Et bHD4P SEULEMENT)
- 6.7 DISPOSITION DES BÛCHES
- 6.8 installation des BRAISES VITRIFIÉES
- 6.9 mise en place du logo
- 7.0 branchement électrique
- 8.0 instructions de fonctionnement
- 9.0 réglages
- 10.0 Entretien
- 11.0 rechanges
- 12.0 accessOires
- 13.0 dépannage
- 14.0 garantie
52
W415-1285 / F / 12.21.16
EN
A. Remove the main door(s) from the appliance see "MAIN DOOR REMOVAL/INSTALLATION" section
for detailed removal instructions.
B. Carefully remove the charcoal embers, charcoal lumps, glowing embers and logs from the appliance.
C. Remove all of the hearth pads, from the appliance. Refer to the "HEARTH PAD INSTALLATION/
REMOVAL" section for instructions.
D. Remove the 4 screws securing the burner in place. Then slide the burner off the orifice and remove
from the appliance.
E. To reinstall the burner, reverse these steps. NOTE: When reinstalling the burner ensure that the
venturi rests on the orifice.
10.5 BURNER REMOVAL
10.5.1 LOG BURNER REMOVAL
A. Remove the main door(s) from the appliance see "MAIN DOOR REMOVAL/INSTALLATION"
section for detailed removal instructions.
B. Vacuum the glass media out of the appliance. Ensure you insert a clean bag into your vacuum
cleaner.
C. Remove the 12 screws securing the media tray, then remove the media tray from the appliance,
as shown below.
D. Remove the 4 screws securing the burner, as shown below. Then slide the burner off of the orifice
and remove from the appliance.
E. To reinstall the burner reverse these steps. NOTE: When reinstalling the burner ensure that the
venturi rests on the orifice.
D
C
10.5.2 GLASS BURNER REMOVAL
D










