manual

25
EN
www.napoleongrills.comN415-0424 MAR 08.18
Leak Tes ng Instruc ons
WARNING! A leak test must be performed annually and each  me a cylinder is hooked up or if a
part of the gas system is replaced.
WARNING! Never use an open  ame to check for gas leaks. Be certain no sparks or open  ames
are in the area while you check for leaks. Sparks or open  ames will result in a  re or explosion,
damage to property, serious bodily injury, or death.
Leak tes ng: This must be done before ini al use, annually, and whenever any gas components are
replaced or serviced. Do not smoke while performing this test, and remove all sources of igni on. See Leak
Tes ng Diagram for areas to check. Turn all burner controls to the o posi on. Turn gas supply valve on.
Brush a half-and-half solu on of liquid soap and water onto all joints and connec ons of the regulator,
hose, manifolds and valves.
Bubbles will indicate a gas leak. Either  ghten the loose joint or have the part replaced with one
recommended by the Napoleon Customer Solu ons department and have the grill inspected by a cer  ed
gas installer.
If the leak cannot be stopped, immediately shut o the gas supply, disconnect it, and have the grill
inspected by a cer  ed gas installer or dealer. Do not use the grill un l the leak has been corrected.
STOP
X