Manualshelf

GD19 Manual

ManualsBrandsNapoleon ManualsFireplacesVittoria Series GD19-1NSB 22" Direct Vent Natural Gas Fireplace with Electronic Ignition, Up to 11,500 BTU's, NIGHT LIGHT, Back-up Control System, Premium Safety Barrier and Heat Radiating Ceramic Glass
41424344454647484950
W415-1351 / 08.29.14
50
EN
A. Remove the safety screen and door from the fi rebox.
B. Run the wires up through the lens hole.
C. Align key hole with lens assembly.
D. Snap into place.
E. Replace light shields, attach the wires and replace the door to the fi rebox.
A. Remove the safety screen, front door and top shield from the fi rebox.
B. Compress the retainer fi ns in with a screw driver while pressing fi rmly on
the top of the light assembly.
C. Once all the retainer fi ns are pushed in the lens assembly will snap out of
place.
KEY HOLE
12.4 NIGHT LIGHT
TM
REPLACEMENT
12.4.1 BULB REPLACEMENT
The GD19 comes equipped with our “Night Light™”. If in the event the lamp or lens needs to be replaced, follow
these instructions.
A. Turn off all electrical supply.
B. Remove the safety screen, front and door from the fi rebox.
C. Unscrew the lens cover making sure the washer stays in place.
NOTE: Do not handle the lamp (bulb) with bare fi ngers, protect with a
clean dry cloth.
D. The lamp will pull straight out of the socket. Replace with Wolf Steel Ltd. parts
only (W387-0009), as lamp and lens are special "high temperature" products.
E. Replace lens with gasket, lens covers, attach wires to quick connects and replace the safety scrren and
door when fi nished.
NOTE: The fi rebox must be sealed.
When re-assembling the light assembly, care must be taken. “Light Leakage” from above the cast doors
may be noticed. The holes in the lamp housing are necessary for ventilation and must not be covered.
12.4.2 LENS ASSEMBLY INSTALLATION
12.4.3 LENS ASSEMBLY REPLACEMENT