Installation Manual

A. Remove safety barrier.
B. Lift the top cast piece off of the appliance.
C. Pull handle and rotate 90°.
D. Slide the door straight up to remove.
Follow the above steps in reverse in order to reinstall the door.
Ensure that the bottom of the door engages the door retainer before
closing the latches.
!
WARNING
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
LATCHES
DOOR
3
2
5.3 GLASS DOOR INSTALLATION AND REMOVAL
5.4 LOG PLACEMENT
LOG LOCATING SCREWS
BRACKET
It is not necessary to remove the cast front, however, this will make for a more simple log installation.
In order to assemble the log set, the glass door must be removed, see “CAST FRONT / GLASS DOOR
INSTALLATION AND REMOVAL” section.
A. Place the rear log, as shown, onto the rear
log support brackets. Ensure the cutout on
the left underside of the log, fi ts over the pilot-
assembly. Bend the bracket on the left side to
help retain the rear log.
!
WARNING
LOGS MUST BE PLACED IN THE EXACT LOCATION IN APPLIANCE. DO NOT CHANGE FROM THE
PROPER LOG POSITIONS. APPLIANCE MAY NOT FUNCTION PROPERLY.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
W415-1332 / A / 11.21.14
27
EN