Installation Sheet

www.napoleongrills.com
11
EN
Minimum Mantel Clearances
WARNING! Mantel temperatures will rise above normal temperatures and may be hot to the
touch.
We recommend that all mantels are made from non-combusble material. If using combusble materials,
follow the chart below.
Note: When using paint or lacquer to nish the mantel, the paint or lacquer must be heat resistant to
prevent discolouraon.
GSS48 / GSS48ST
8” (203mm) Mantle
6”(152mm)
4”(102mm)
2”(51mm)
Top of Fireplace
24”
(610mm)
26”
(660mm)
22”
(559mm)
20”
(508mm)
23”
(584mm)
6”(152mm)
All material in shaded
area must be Non
Combusble. (including
framing, sheeng and
nishing materials).
NON COMBUSTIBLE
Drain Installaon (Recommended)
Although this replace is designed to operate outdoors safely, rain and other sources of moisture may
enter the replace area, which will cause water to collect inside the base of the unit within the replace
enclosure. When choosing a locaon for your replace, care must be taken to avoid areas where excessive
moisture or running water may be a problem.
To prevent moisture or water from collecng underneath the replace, the builder must provide a means
to drain water from under the replace, before posioning the replace in its locaon. It is recommended
that a sealed corrosion resistant drain pan with provisions for drainage be posioned underneath
the replace. The drain pan can be constructed from corrosion resistant metal, or other suitable
materials such as an ice and water shield membrane. A means of drainage out of the drain pan such as
piping or weep holes must also be provided. A slope of 1/4” (6mm) per foot towards the drain port is
recommended.
Note: When planning for the installaon of the replace the framing height must be increased to
accommodate a drain pan and any addional drainage piping required.
Note: The replace must be installed on a level surface to ensure proper drainage.