Installation Sheet

www.napoleongrills.com

Burner: The burner is made from heavy wall 304 stainless steel, but extreme heat and a corrosive

environment can cause surface corrosion to occur. This can be removed with a brass wire brush. Inspect

the burner at least annually for cracks, insect nests, excessive corrosion or any other damage. If the

burner is damaged, it must be replaced with a burner specied by the manufacturer before the appliance

is put into operaon.

CAUTION! Beware of Spiders.

Spiders and insects are aracted to the smell of propane and natural gas. The burner is equipped with an

insect screen on the air shuer, which reduces the likelihood of insects building nests inside the burner

but does not enrely eliminate the problem. A nest or web can cause the burner to burn with a so

yellow or orange ame or cause a re (ashback) at the air shuer underneath the control panel. Other

warning signs that may indicate a problem are:

• Strong or unusual odor coming from the appliance.

• Connued diculty or delayed ignion.

• Flame appears either very short or very long.

• Flame only burns part way across the burner.

• Excessive soot building up on the glass embers.

To clean the inside of the burner, it must be removed from the appliance: Remove the front glass shield

and the glass embers and examine the burner. If dirty, clean with a wire brush. Remove the screws that

aach the glass ember tray and the wind shield. Cleaning: Use a exible venturi tube brush to clean the

inside of the burner. Shake any loose debris from the burner through the gas inlet. Check the burner ports

and valve orices for blockages. Burner ports can close over me due to debris and corrosion, use an

opened paperclip or a drill bit to clean them The ports are easier to clean if the burner is removed from

the appliance, but it can also be done with the burner installed.

Li the glass tray from the replace, pushing from the top, disengage the thermocouple and igniter from

the glass tray.

Remove the ex hose and the orice from the burner and completely remove the glass tray from the

replace.