Installation Manual

27
EN
W415-1367 / 12.05.14
6.4 FRAME/FRONT INSTALLATION
A. Align the two holes in the upper portion
of the hinge on the control door to those
in the bottom trim bracket, secure using
two of the #8 x 1/2" hex head screws
supplied.
B. Install the top trim bracket to the fi rebox
using the three #9 - 14 x 1/2" hex head
screws supplied in the
manual
baggie.
C. Rest the top lip of the frame on
the top trim bracket, and the securing tabs at the bottom
of the frame on the bottom trim bracket.
D. Align the two slots in the top of the frame with the two holes in the top trim bracket and secure
using the two #10 pan head screws supplied however do not fully tighten to leave room for adjustment.
E. Align the holes in the securing tabs at the bottom of the frame with the holes in the bottom trim
bracket and secure using the two remaining #8 x 1/2" hex
head screws, however do not fully tighten to leave room for
adjustment.
F. If required, the bottom trim bracket can be adjusted by
loosening it’s securing screws.
G. Once the frame is perfectly square and the control
door will close without rubbing against the sides of the
frame, tighten all screws.
H. Open the control door.
I. Insert the door stop chain into the receiving slot in the
control door.
J. Insert the door stop chain into the receiving slot in the
frame so that when fully open the control door has
a clearance of 1/8" to the fi nished wall. NOTE: In most
cases, a count of 9 balls between receiving slots will
give the desired clearance.
K. Close the control door.
The frame has been designed to accommodate fi nished
material thicknesses of 1/2" - 3/4" (13mm - 19mm). If it is
necessary to pull the frame out to the max. 3/4" (19mm)
the magnetic catch will need to be adjusted. Minor adjustment
can be made by removing shims from behind the magnet. Major
adjustments can be made by moving the magnet to the outside of
the panel.
Adjustment may be required to accommodate the door stop
chain slack when the control door is closed. The control
door securing screws can be loosened to allow
adjustment. Before
re-tightening the
screws ensure the
control door is still
recessed into the
frame at a
similar offset to the
top trim piece.
CONTROL
DOOR
BOTTOM
TRIM
BRACKET
TOP
TRIM
BRACKET
BOTTOM
TRIM
BRACKET
TOP
TRIM
BRACKET