Full Product Manual

www.napoleongrills.com
13
EN
WARNING!Glassembersmayhavesharpedges,wearsafetyglassesandgloveswhenhandling.
Donotchangeorsubstutetheglassembermaterialprovidedwiththisappliance.Ifreplacing,use
onlyreplacementglassembersavailablefromyourlocalauthorizeddealer/distributor.
WARNING!Toavoidthepossibilityofburns,maintenanceshouldbedoneonlywhenthe
applianceis.Avoidunprotectedcontactwithhotsurfaces.Ensureburneristurnedo.Turngasoat
sourceanddisconnecttheappliancebeforeservicing.Cleantheapplianceinanareawherecleaning
soluonswillnotharmdecks,lawns,orpaos.Donotuseammable,corrosiveorabrasivecleaners.
Note: Stainless steel tends to oxidize or stain in the presence of chlorides and suldes, parcularly in
coastal areas and other harsh environments, such as the warm, highly humid atmosphere around pools
and hot tubs. These stains could be perceived as rust, but can be easily removed or prevented. To provide
stain prevenon and removal, wash all stainless steel and chrome surfaces every 3-4 weeks or as oen as
required with fresh water and/or stainless steel cleaner.
ControlPanel: The control panel text is printed directly on the stainless steel and with proper
maintenance will remain dark and legible. To clean the panel, use only warm soapy water or stainless steel
cleaner available from your Napoleon dealer. Never apply abrasive cleaners on any stainless surfaces,
especially the printed poron of the control panel or the prinng will gradually rub o.
Maintenance/CleaningInstrucons
Burner: The burner is made from stainless steel, but extreme heat and a corrosive environment can cause
surface corrosion to occur. This can be removed with a brass wire brush. Inspect the burner at least
annually for cracks, insect nests, excessive corrosion or any other damage. If the burner is damaged, it
must be replaced with a burner specied by the manufacturer before the appliance is put into operaon.
CAUTION!BewareofSpiders.
Spiders and insects are aracted to the smell of propane and natural gas. The burner is equipped with an
insect screen on the air shuer, which reduces the likelihood of insects building nests inside the burner
but does not enrely eliminate the problem. A nest or web can cause the burner to burn with a so yellow
or orange ame or cause a re (ashback) at the air shuer underneath the control panel. Other warning
signs that may indicate a problem are:
• Strong or unusual odor coming from the appliance.
• Connued diculty or delayed ignion.
• Flame appears either very short or very long.
• Flame only burns part way across the burner.
• Excessive soot building up on the glass embers.
Tocleantheinsideoftheburner,itmustberemovedfromtheappliance: Remove the glass embers and
examine the burner. If dirty, clean with a wire brush.
Cleaning: Use a exible venturi tube brush to clean the inside of the burner. Shake any loose debris from
the burner through the gas inlet. Check the burner ports and valve orices for blockages. Burner ports can
close over me due to debris and corrosion; use an opened paperclip or a drill bit to clean them. The ports
are easier to clean if the burner is removed from the appliance, but it can also be done with the burner
installed.
WARNING!Hose:Checkforabrasions,melng,cuts,andcracksinthehose.Ifanyofthese
condionsexist,donotusetheappliance.HavethepartreplacedbyyourNapoleondealerorqualied
gasinstaller.
CleaningInsideTheAppliance: While washing your appliance, be sure to keep the area around the burner
and pilot assembly dry at all mes.
WARNING!Ifthegascontrolisexposedtowaterinanyway,DONOTtrytousetheappliance.
Thegascontrolmustbereplaced.