Full Product Manual

www.napoleongrills.com
5
EN
Correct Disposal Of This Product
This marking indicates that this product should not be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material resources. To return your used device,
please use the return and collecon systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
GasCylinder
Use only gas cylinders, which meet naonal and regional codes. The minimum cylinder size for butane
units is 13kg, and for propane units is 6kg. Ensure that the cylinder can provide enough fuel to operate the
appliance. If in doubt, check with your local gas supplier.
• Use cauon when handling the cylinder valve.
• Never connect a cylinder, which does not meet local codes.
• All cylinders 7kg or larger must be placed outside the enclosure on level ground. Cylinders smaller
than 7kg (maximum size 465mm high by 306mm wide) may be placed inside the enclosure. Only
cylinders connected to the appliance may be stored in the enclosure, or close to the appliance. Spare
cylinders must not be stored in the enclosure, or in close proximity of an operang unit. Cylinders
must not be exposed to extreme heat or direct sunlight.
WARNING!Ensurethatthehoseisroutedtomaintainproperclearancetotheundersideofthe
unit.Hosesthatcontacthightemperaturesurfacesmaymeltandleak,causingare.
CylinderConnecon:Remove the cap or plug from the cylinder fuel valve. Tighten regulator to cylinder
valve. Leak test all joints prior to using. A leak test must be performed annually, and each me a cylinder is
hooked up, or if a part of the gas system is replaced.
GasHose
• If the hose and regulator are not included by the manufacturer, then only hoses and regulators which
meet naonal and regional codes are to be used.
• Ensure that the gas hose does not come into contact with any hot surfaces on the appliance -
parcularly the underside of the burner.
• Check hose regularly. In the case of rips, melng or wear, replace hose before using the appliance.
• The recommended hose length is 0.9m. The hose must not be longer than 1.5m.
• Ensure that the hose is twist and kink free when installed.
• Replace the hose before expiry date printed on the hose.
TechnicalData
The following table lists input values for the appliance.
Orice Size (Gross) Heat Input (Total) Gas Usage (Total)
I II III I/II III
#51 #53 #36 11.5 kW 837 g/hr 1092 L/hr
Cered Gases / Pressures - Check rang plate to ensure that it corresponds with following list.
Do not tamper with or modify regulator. Use only regulators which supply the pressure listed in the table
above. For replacement, use only the regulator specied by the manufacturer.
Gas Category
I
3B/P(30)
I
3+(28-30/37)
I
3B/P(50)
I
2H
I
2E
I
2E+
Orice Sizes(see
above)
I I II III III III
Gases / Pressures Butane and Pro-
pane at 30mbar
Butane 28-
30mbar Propane
37mbar
Butane and
Propane at
50mbar
G20 at 20mbar G20 at
20/25
mbar
G20/G25 at
20/25 mbar
Countries BE, BG, CY, DK, EE,
FI, FR, GB, HR, HU,
IS, IT, LT, LU, MT,
NL, NO, RO, SE, SI,
SK, TR
BE, CH, CY, CZ,
ES, FR, GB, GR,
IE, IT, LT, LU, LV,
PT, SK, SI
AT, CH, DE,
SK
AT, BG, CH, CZ, DK,
EE, ES, FI, GB, GR,
HR, HU, IE, IS, IT,
LV, LT, NO, PT, RO,
SE, SI, SK, TR
DE, LU, PL BE,FR