Project Ideas

10
EN
www.napoleon.com
N415-0417 APR 30.20
PLANNING YOUR NAPOLEON MODULAR OUTDOOR ISLAND
With OASIS™ Modular Islands you can transform your backyard into a true barbecue oasis. The versale
modules can be arranged in a way that ts your grilling needs. OASIS™ outdoor kitchens can be freestanding or
mounted against a non-combusble wall.
The cabinets are designed to be easy to assemble and install by either the home owner or private contractor.
Consider the following:
• All cabinets are 35” (889 mm) tall by 24” (610 mm) deep and 24” (610 mm) wide, except for the BUILT-IN
grill cabinets whose width correspond to the width of the grill head unit it was designed for.
• The fridge cabinet has a removable panel which allows access to the temperature control located at the
back of the fridge. Access to the panel must be ensured when the cabinet is installed.
• Each cabinet has 4 leveling feet for adjustment on even surfaces.
• The 2 drawer cabinets are made to t the Napoleon BUILT-IN series of grills only, which are available in
dierent sizes. Grill head installaon and operaon instrucons are detailed in the Owner’s Manual that
comes with it.
• The BUILT-IN series of grills can be ordered in either propane or natural gas conguraon. Knockouts are
present in the side and rear panels for easy piping and installaon. For those who order a propane grill, a
propane tank cabinet is available.
• The cabinets can be installed against a NON-COMBUSTIBLE wall of a house, a masonry or stucco half-wall,
or freestanding in an island conguraon.
• Ensure there is adequate venlaon behind the fridge cabinet – a minimum gap of 6” (150 mm) is required
between the back of the cabinet and adjacent structures.
• An oponal 4” (102 mm) spacer panel can be purchased and installed to ensure enough clearance for the
grill lid to open when installing against a wall. It also prevents debris or rodents from entering behind the
cabinets.
• A powder-coated 2” (51 mm) wide end panel can be purchased to cover the knockouts and mounng
holes in the outside panels in a run of cabinets, oering a nished look.
WARNING! All gas modicaons and/or installaons must be done by a qualied gas installer.
WARNING! Never block the vents located on the back of the fridge cabinet. Failure to do so can result
in the fridge overheang.
WARNING! Never place the fridge and fridge cabinet next to the grill head and grill head cabinet.
It is recommended to use the false top drawer module IM-2DC when:
• Doors and drawers get in the way of each other if placed next to a 45
o
or 90
o
transion.
• A drawer, door, or paper towel/garbage module is placed next to the grill and the control panel prevents
them from fully opening and possible damages them.
• A side burner kit (oponal through your Napoleon Gas Grill dealer), or a sink will be installed. The space
behind the false drawer oers enough clearance for the side burner valve and hose roung and for the
sink’s piping.
Counter top: must be ordered and supplied locally by the homeowner.
• It must be made of NON-COMBUSTIBLE material for a grill to be installed into it.
• It can be ordered in advance by drawing out the cabinet’s arrangement oor plan and adding up the width
measurements, allowing 1-2 inches (25 mm - 51 mm) of counter top overhang.
TIP! Most counter top manufacturers are willing to come and take measurements aer assembling the
cabinets to ensure a perfect t. Granite or Corian are recommended choices of counter top materials.
• In order for the drip pan to slide in and out properly, the grill head must be supported by a counter top
with a thickness between ½” (13 mm) and 1 ½” (38 mm).
• The built-in grill head comes with stainless steel brackets and hardware that allow the unit to rest on the
counter top above the corresponding island cabinet.
• Decorave counter tops made of ceramic le set on top of cement ling board can be made to match your
surrounding backyard furniture colors.
!
!