Installation Sheet

W415-1707 / 07.04.17
EN
4
table of contents
1.0 general information 5
1.1 rates and efficiencies 6
1.2 installation overview 7
1.3 rating plate/lighting instruction
location 9
1.4 mobile home installation 10
1.5 hardware list 10
1.6 lifting handles installation/removal 10
2.0 dimensions 11
2.1 single-sided 11
2.2 see-thru 12
3.0 minimum venting requirements 13
3.1 typical venting installation 15
3.2 minimum air terminal location
clearances 19
3.3 venting definitions & information 20
3.4 horizontal termination 20
3.5 vertical termination 22
4.0 rough framing 23
4.1 minimum framing dimensions 24
4.1.1 minimum clearance to combustible
enclosures 25
5.0 venting installation 28
5.1 firestop spacer assembly 28
5.2 horizontal installation 30
5.3 vertical installation 30
5.4 using flexible vent components 31
5.4.1 horizontal air terminal installation 31
5.5 vertical air terminal installation 32
5.5.1 appliance vent connection 32
5.6 vent shield installation 33
6.0 electrical information 34
6.1 hard wiring connection 34
6.2 receptacle wiring diagram 34
6.3 in the event of a power failure 34
6.4 access panel 35
6.5 battery back-up installation 36
6.6 wiring diagram 37
7.0 gas installation 38
8.0 operation 39
9.0 nailing tab installation 40
10.0 finish framing 41
10.1 framing with non-combustibles 41
11.0 finishing 45
11.1 fastener placement restriction 45
11.2 finishing with non-combustibles 46
11.3 installing non-combustible board 47
11.4 minimum combustible mantel
clearances 49
11.5 safety barrier installation / removal 50
11.6 anti condensation switch 50
11.7 firebox glass door installation /
removal 50
11.8 glass media installation / removal 52
11.9 optional media placement 52
The information throughout this manual is believed to be correct at the time of printing. Wolf Steel
Ltd. reserves the right to change or modify any information within this manual at any time without
notice. Changes, other than editorial are denoted by a vertical line in the margin.
note:
12.0 adjustments 53
12.1 restricting vertical vents 53
12.2 venturi adjustment 53
12.3 pilot burner adjustment 54
12.4 flame characteristics 54
13.0 maintenance 55
13.1 annual maintenance 56
13.2 control access 56
13.4 burner removal 57
13.3 valve removal 57
13.5 control module removal 58
13.6 glass / door replacement 59
13.7 care of glass 59
13.8 care of plated parts 59
14.0 replacements 60
14.1 overview 61
14.2 burner components 62
15.0 troubleshooting 63