Owner's Manual

EN
13
4.0 fi nishing
4.1 front surround removal / installation
A. Unplug the LED back lights (see “LED back lights” section).
B. With one hand on the front surround to prevent it from falling, remove the two screws (1 per side) from the
top of the appliance (Fig. 4-1). Set the screws aside.
C. Carefully lift the front surround up and away from the appliance (Fig. 4-2). Place it face down on a soft,
non-abrasive surface.
D. Reverse these steps to install the front surround.
!
WARNING
• Power supply service must be completed prior to fi nishing to avoid reconstruction.
• Heat vents and air openings cannot be covered in any circumstances.
Repeat on
opposite side.
Fig. 4-1
Fig. 4-2
4.2 crystal / pebble media installation
A. Remove the front surround (see “front surround removal / installation”
section).
B. Clean crystal media: Crystal media may have a fi ne oil residue that
needs to be cleaned prior to installation. Clean the crystal with mild
dish soap, drain, rinse thoroughly and dry before placing into the tray.
C. Remove the log set from the media tray (if applicable).
D. Place the media tray onto the front of the appliance opening
E. Carefully place crystals or pebbles into the bottom tray on the front of
the appliance as illustrated. Apply an even layer from side to side. Re-
secure the glass panel.