Use and Care Manual

NOTE: To aid with moving the appliance, leave enough wire so that the appliance can be removed
from the enclosure without disconnecting the power supply. If servicing, shut off power supply.
BLACK
WHITE
BLACK
WHITE
GREEN
GREEN
GROUND
BLACK
BLACK
BLACK
WHITE
WHITE
WIRE NUT
WALL
SWITCH
POWER
SUPPLY
MARRET
RED
RED
RED
RED
GREEN
GREEN
THERMOSTAT
(L1)
(N)
(G)
WIRE NUT
(L1)
(N)
(L1)
(N)
Fig. 1
Fig. 2
EN
W415-1662 / A / 06.06.16
11
3.3.2 APPLIANCE INSTALLATION
A. With two people, lift the appliance up and insert into the opening, keeping a 3/8" (9.5mm) space
between the appliance and floor base in order to not scratch the floor surface. Do not push or slide
the bottom of the appliance on the floor base, see Figure 1.
B. Set the appliance down and into place, see Figure 2.
C. If the appliance does not sit flat on the floor or mantel base, apply a shim (not supplied) under the
nylon pads and adjust until level.
MANTEL
TABLETTE
APPLIANCE
APPAREIL
1/4"
MANTEL
TABLETTE
APPLIANCE
APPAREIL
STEP 1: LIFT
ÉTAPES 1: SOULEVER
STEP 2: INSERT
ÉTAPES 2: INSÉREZ
STEP 3: SET APPLIANCE
ÉTAPES 3: RÉGLÉ APPAREIL
DO NOT SLIDE APPLIANCE
NE GLISSEZ PAS L'APPAREIL
!
!
MANTEL
TABLETTE
APPLIANCE
APPAREIL
1/4"
MANTEL
TABLETTE
APPLIANCE
APPAREIL
STEP 1: LIFT
ÉTAPES 1: SOULEVER
STEP 2: INSERT
ÉTAPES 2: INSÉREZ
STEP 3: SET APPLIANCE
ÉTAPES 3: RÉGLÉ APPAREIL
DO NOT SLIDE APPLIANCE
NE GLISSEZ PAS L'APPAREIL
!
!
MANTEL
MANTEL
F
NOTE: This appliance is equipped with nylon pads located on the bottom four corners. To prevent
damaging the base of the mantel, carefully lift the appliance into the mantel while avoiding contact
with the front edge of the mantel base.