Warranty

EN
W415-2212 / E / 06.27.18
19
installation
BLACK (L1)
WHITE (N)
YELLOW (N1)
YELLOW (N2)
GREEN (G)
(G)
(N)
(L1)
(L2)
RED (L2)
White, black, red, and
green wires:
Connect to 240V
power supply.
Leave enough wire so that the appliance can be removed from the enclosure without disconnecting the
power supply.
note:
GROUND
BLACK
BLACK
BLACK
WHITE
WHITE
WIRE NUT
WALL
SWITCH
POWER
SUPPLY
MARRET
RED
RED
RED
RED
GREEN
GREEN
THERMOSTAT
(L1)
(N)
(L1)
(N)
BLACK
WHITE
BLACK
WHITE
GREEN
GREEN
(L1)
(N)
(G)
WIRE NUT
RED
(L2) (L1)
(N)
(G)
120V
GREEN (G)
GREEN (G)
RED (L2)
RED (L2)
BLACK (L1)
WHITE (N)
YELLOW (N2)
YELLOW (N1)
BLACK (L1)
WHITE (N)
240V
1. Remove the securing screw from the electrical cover plate located on the rear left side of the appliance.
2. Loosen the securing screw from the terminal block to remove the cord from the terminal block. REMOVE 2
WIRE JUMPERS IN THE TERMINAL BLOCK.
3. Add an electrical box connector and feed the supply wires through the 7/8” (22mm) hole from the terminal
block.
4. Insert White (N) wire from power supply to the designated (N) slots in the terminal block. Secure by tightening
the screws on the (N) slots.
5. Repeat step 4 with Black (L1), Red (L2) and Green (G), securing them to their designated slots in the terminal
block.
6. Re-install cover plate.