Warranty

EN
W415-2212 / E / 06.27.18
21
finishing
• Power supply service must be completed prior to finishing to avoid reconstruction.
• Heat vents and air openings cannot be covered in any circumstances.
!
WARNING
6.0 finishing
6.1 crystal ember installation
6.2 optional topaz glass chips and drift wood log installation
The front glass must be removed and the appliance must be secured in its final location before the optional topaz glass
chips and drift wood logs are installed (CHD models only) (see “front glass installation and removal” section).
Recommended drift wood log placement for NEFL50CHD
The glass front must be removed and the appliance must be secured in its final location before the crystal embers
are installed (see “front glass installation and removal” section).
For NEFL42 / 50 / 60 / 74 / 100CHD, place the small crystal embers
into the media tray, applying an even layer from side to side. Next,
randomly place the large crystal embers on top of the small crystal
embers.
note:
1. Carefully place crystal embers into the bottom media tray (FIG. 1).
2. Apply an even layer from side to side.
1. Carefully place drift wood logs on the media tray.
2. Use the topaz glass chips to fill in spaces between the drift wood logs. This will improve the overall look of the
appliance.
FIG. 1
Ensure to remove the 2 screws from the plastic ember bed panel before applying crystals embers and/or logs.
note:
Recommended drift wood log placement for NEFL42CHD
A
A
A1
B
B1
C1
C
D
Reference Log Number
A W135-0728
A1 W135-0728 Rear Side
B W135-0729
B1 W135-0729 Rear Side
C W135-0730
C1 W135-0730 Rear Side
D W135-0731