Warranty

EN
W415-2212 / E / 06.27.18
25
operation
8.0 operation
Once the appliance has been plugged into a grounded electrical outlet, it is ready to operate.
The control panel is located on the lower right-hand corner of the appliance.
8.1 operating control panel
Power
Turns the appliance on/off.
Orange Flame
Controls flame brightness.
Settings:
F0 - Flame off
F1 - Small flame
F2 - Medium flame
F3 - Bright flame
F4 - Brightest flame
Blue Flame
Heater
Turns the heater and blower on/off.
Settings:
H0 - Heater and blower off
BL - Blower on
H1 - Low heat
H2 - High heat
H3 - High heat with blower boost
Ember Bed Light
Controls ember bed light settings.
Settings:
L0 - Ember bed light off
L1 - White
L2 - Blue
L3 - Green
L4 - Red
L5 - Yellow
L6 - Purple
L7 - Auto-cycle through white, blue, green, red, yellow, and
purple. (NOTE: It will take 3 seconds to switch between
colours.)
L8 - Lock to desired color
ºF / ºC
To change the temperature to Celsius or Fahrenheit, press
and hold the yellow flame button for 5 seconds.
Heater Lock
Heater button can be locked or unlocked by holding the
heater button for 5 seconds.
Temperature
Control
Press and hold the blue flame button for 5 seconds. This will
change the blue flame button to temperature control or vice-
versa. There are 7 temperature settings: 61ºF [16ºC], 64ºF
[18ºC], 70ºF [21ºC], 75ºF [24ºC], 81ºF [27ºC], 85ºF [29ºC], and
OFF.
hold 5 seconds
hold 5 seconds
hold 5 seconds
Ensure the house circuit breakers for the power supply are turned on. In the event of a power failure, the
appliance will lose its memory function and will reset to factory mode when the power returns.
attention: