Installation Guide

3.5 HARD WIRING INSTALLATION

HARD WIRING CONNECTION

If it is necessary to hard wire this appliance, a qualiﬁed electrician must remove the cord connection, and wire

the appliance directly to the house hold wiring.

This appliance must be electrically connected and grounded in accordance with local codes, if hard wired.

In the absence of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the

current ANSI/NFPA 70 NATIONAL ELECTRICAL CODE in the United States.

WARNING

TURN OFF THE APPLIANCE COMPLETELY AND LET COOL BEFORE SERVICING. ONLY A QUALIFIED

SERVICE PERSON SHOULD SERVICE AND REPAIR THIS ELECTRIC APPLIANCE.

A. Remove the cover plate from the right side

bottom of the appliance by removing the

3 screws (FIG 1).

B. Remove the wire connectors from the

power cord. The power cord may be

discarded.

C. Take the new cover plate, supplied in the hardware bag (FIG. 2). Punch out the 7/8" (22.2mm) hole

and install a box connector through, into the junction box. Snap the box connector clamp onto the

supply wires.

D. Using the wire connectors, connect the ground green wires (G), the common white wires (N)

together, then the hot black wires (L) (FIG. 3, 4).

E. Reinstall the cover plate using the 3 screws (FIG. 1).

FIG. 1

COVER PLATE

FIG. 3

FIG. 2

FIG. 4

7/8" (22.2mm)

Diameter

W415-1542 / D / 11.10.17