Installation Guide
EN
W415-1542 / D / 11.10.17
17
FIG. 3
The glass front must be removed and the appliance must be secured in its final location before the crystal
embers are installed.
A. Carefully place crystal embers into the bottom media tray on the front
of the appliance as illustrated.
B. Apply an even layer from side to side.
A. Remove the 2 screws from the top of the appliance, as shown below.
B. Have 2 people, lift the glass up and away from the appliance, holding the glass vertical not flat while
carrying. Place the glass face down onto a soft, non-abrasive surface, careful not to flex the glass.
C. Install the crystal embers. See "CRYSTAL EMBER INSTALLATION" section. Install the front glass by
aligning with the pins on the appliance. This ensures the touch display panel performs properly.
FOR WALL MOUNT, PARTIAL RECESS AND MANTEL INSTALLED APPLIANCES ONLY:
4.2 FRONT GLASS REMOVAL
4.3 CRYSTAL EMBER INSTALLATION