Manualshelf

Full Product Manual

ManualsBrandsNAPOLEON ManualsElectric FireplacesAllure Phantom 42 in. Wall Mount Electric Fireplace with Mesh Screen
11121314151617181920
EN
W415-2172 / 08.08.16
17
FIG. 3
The mesh trim front must be removed and the appliance must be secured in its final location before the crys-
tal embers are installed.
A. Carefully place crystal embers into the bottom media tray on the
front of the appliance as illustrated. Apply an even layer from side
to side.
B. Ensure that no crystal embers touch the mesh trim front during
install. Avoid crystal embers scratching/tearing mesh.
A. Remove the 2 screws from the top of the appliance, as shown below.
B. Have two people, lift the mesh trim up and away from the appliance, holding the mesh trim vertical
not flat while carrying. Place the mesh trim face down onto a soft, non-abrasive surface, careful not
to flex the mesh trim.
C. Install the crystal embers, refer to "CRYSTAL EMBER INSTALLATION" section. Install the front
mesh trim by aligning with the pins on the appliance. This ensures the touch display panel performs
properly.
FOR WALL MOUNT, PARTIAL RECESS AND MANTEL INSTALLED APPLIANCE ONLY:
4.2 MESH TRIM FRONT REMOVAL
4.3 CRYSTAL EMBER INSTALLATION