Installation Guide

W415-0702 / 10.30.08
27
SET SCREW
SET
SCREW
The trivet for the insert is attached by two set screws on the inside of the hopper lid.
● Secure the Right Flashing to the
right side of the heater using two
of the #8 x 1/2" screws.
NOTE: Feed the Air Control Rod into
the Air Control Slot on the Right
Flashing before securing.
● Twist spring handle (supplied
with the heater) onto the air
control rod until it hits the stop.
● Remove the two control panel
securing screws, discard the screws
and shipping bracket.
● Secure the control panel to the right
Flashing using the two #8 x 3/8" screws.
Secure the Left Flashing with the
remaining #8 x 1/2" screws.
● Align the holes in the top of the right
and left Flashing with those on the
bottom lip of the Top Flashing and
secure from the rear using the four
#8-32 x 3/8" screws, washers and nuts.
● The three pieces of trim are assembled in
the same manner as a picture frame. Place
the corner brackets (with screw loosened)
into the trim sections. Tighten the screw
spreading the two pieces apart. Attach the
adjoining section. Repeat with the opposite
side. Tighten all screws firmly.
● Slide the assembled trim down over the flashing.
● Affix the logo to the bottom left hand corner of the left flashing.
L
O
W
H
I
G
H
1
2
3
4
5
L
O
W
H
I
G
H
1
2
3
4
5
CONTROL
PANEL
AIR CONTROL
ROD
AIR CONTROL
SLOT
RIGHT
FLASHING
BURN
RATE LABEL
PUSH TO START / POUSSEE POUR COMMENCER
W385-0355
5
3
1
2
4
OPTIMUM
1
3
5
4
2
1
3
5
4
2
SHIPPING
BRACKET
SECURING
SCREWS
CONTROL
PANEL
SECURING
SCREWS
TOP
FLASHING
TRIM
ASSEMBLY
TRIM
UNDERSIDE
CORNER
BRACKET
FIGURE 7.1.3
FIGURE 7.1.7
FIGURE 7.1.3
FIGURE 7.1.5
FIGURE 7.1.4
7.0 INSERT FINIShING
7.1 FLAShING INSTALLATION
7.2 TRIvET INSTALLATION
FIGURE 7.1.1
FIGURE 7.2
TP - FLASHING INSTALLATION_PELLET
TP - TRIVET INSTALLATION_PELLET
7.1.1
7.1.2
7.1.3
7.1.4
7.1.5
7.1.6
7.1.7
7.1.8