Installation Guide

W415-0702 / 10.30.08
28
Before installing this heater we recommend a “PRE-BURN” inspection to help burn off the odors that are associated with
the first burn. If possible, move the heater outside and add approximately 5 lbs of pellets into the hopper. Plug the power
cord into a typical wall receptacle.
The heater is equipped with a control board that has been shipped in manual mode.
When first starting a new pellet heater, or when you completely empty the hopper of pellets you can press and hold the
auger feed button to get the pellets into the burn pot quicker.
● Press the ON / OFF button:
Both blowers come on at line voltage. After 15 seconds the convection blower will shut off.
● The green “POWER” button will flash indicating that the start-up cycle has begun. The red “HEAT” light comes on
at setting #1.
● The auger comes on and runs for approximately 3 minutes.
● The igniter comes on and will stay on until proof of fire determined by the heater temperature.
● Approximately 5 minutes after commencing the start-up cycle the auger will start feeding at level #1 until proof of fire.
NOTE: Flame should appear in the burn pot within 3 to 7 minutes from commencing the start-up cycle. The
start-up cycle should end in approximately 12 to 15 minutes. At this point adjustments to feed rate can be made or
the heater will revert to the previous setting.
If proof of fire is not established in 15 minutes, the heater will shut down and will need to be turned back on again.
If the heater shuts down, empty the pellets from the burn pot and restart.
The main viewing door has been boxed separate from the heater, but MUST be installed before burning
the heater.
● Open both side panels, exposing the bushing on the left and the latches on the right.
● Align the pins on the door to the bushing on the left side of the heater. Lower into
place until both bushings touch.
● Engage the latch hooks into the door frame. Snap the rear handle hook to
lock the latch closed.
INSERT ILLUSTRATED
7.3 INSTALLING vIEWING dOOR
8.0 OPERATING INSTRUCTIONS
8.1 PROPER PELLET LOAdING
8.2 PRE-START ChECk
Before loading pellets into the hopper first transfer the pellets from it's original plastic bag to a metal bucket.
Keep in mind that the auger stops when the lid is opened. If the lid is opened for several minutes, the fire may
extinguish.
NOTE: If the pellets are kept in the plastic bag, the bag may come in contact with the heater causing
the bag to melt and the pellets to spill.
DO NOT load pellets into the hopper if they have been exposed to moisture. Moisture can cause pellets
to swell and cause blockage in the feed system. Thoroughly dry pellets before placing into hopper.
FIGURE 7.3.2
TP - INSTALL VIEWING DOOR_PELLET
TP - PROPER PELLET LOADING
TP - PRE-START CHECK
7.3.1
7.3.2
7.3.3
8.2.1
8.2.2
8.2.3
8.2.4
8.2.5