Installation Guide

W415-0702 / 10.30.08
5
During a power outage this heater will
not operate. If a power outage does
occur, check the heater for smoke
spillage and open a window if any
smoke spills into the room.
Keep foreign objects out of the
hopper.
Disconnect the power cord before
performing any maintenance.
NOTE:
Turning the Pellet Feed dial to “OFF”
does not disconnect all power to the
heater.
Do not throw this manual away. This
manual has important operating and
maintenance instructions that you will
need at a later time. Always follow the
instructions in this manual.
This heater must be connected to a
standard 115 V., 60Hz grounded
electrical outlet. Do not use an
adapter plug or sever the grounding
prong. Do not route the electrical cord
underneath, in front of, or over the
heater.
When installed in a mobile home, the
heater must be bolted to the floor,
have outside air, and NOT BE
INSTALLED IN THE BEDROOM (Per
H.U.D. requirements). Check with
local building officials.
The exhaust system should be
checked and cleaned once a year
minimum for any build-up of soot or
creosote.
Combustible materials such as
firewood, wet clothing, etc. placed too
close can catch fire.
Objects placed in front of the heater
must be kept a minimum of 48" from
the front face of the heater.
?
Operating
Manual
This heater can become very hot, you
MUST wear heat resistant gloves
when cleaning or handling this heater.
At no point should you use firewood or
firelogs in this heater. The use of
which could cause a house fire.
TP - PELLET WARNING 2