Owner Manual

W415-1966 / 07.08.19

A. Ensure that the access cover plate has been installed.

B. Remove the on/off switch bracket and the cover plate

below it. The cover plate may now be discarded.

C. Decide which side of the blower housing you prefer the

on/off switch to be located on.

D. Remove the 2 screws from the top outer edge of the rear

appliance panel. The housing is mounted using these

two holes, as well as two other holes located in the rear

panel.

E. Mount and secure the blower housing using 4 screws.

Ensure that the on/off switch wires pass through the

appropriate slot located on either side of the blower

housing.

F. Remove the 2 screws from the side of the blower

housing that you want the switch to be located on and

re-secure the on/off switch.

Because the blower is thermally activated, when turned on, it will

automatically start approximately 15-30 minutes after lighting the

appliance and will run for approximately 30-45 minutes after the

appliance has been turned off. Use of the fan increases the output

of heat.

Drywall dust will penetrate into the blower bearings, causing

irreparable damage. Care must be taken to prevent drywall

dust from coming into contact with the blower or its compartment.

Any damage resulting from this condition is not

covered by the warranty policy.

SLOT

REMOVED SCREWS

6.0 blower installation

ACCESS PLATE

COVER

PLATE

ON/OFF

SWITCH

BRACKET