Installation Manual

Table Of Contents

W415-1642 / A / 08.25.16

6.2 DOOR GLASS REPLACEMENT

A. Lift the screen up into the appliance.

B. Lower the glass door down and unlatch. Swing

the glass door open.

C. Unscrew the top and bottom retainers inside

door frame. (FIG.1)

D. Remove glass from door frame. (FIG.2)

E. Center and apply gasket to the edge of glass.

Ensure gasket is a continuous loop around the

perimeter of the replacement glass. (FIG.3)

WARNING

DO NOT USE SUBSTITUTE MATERIALS.

GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.

CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR

DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE

APPLIANCE BEFORE OPERATION.

DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS

REMOVED, CRACKED, BROKEN OR SCRATCHED.

56.1C

Replacement glass/frame assembly shall be replaced as a complete unit as supplied by the

appliance manufacturer.

At the end of each burning season inspect the door gasket ensuring that it is not worn or loose. Replace with

proper ﬁberglass rope. The purpose of door gasketing is to seal the ﬁrebox. If the doors are not sealed, air leaks

into the ﬁrebox, creating a quick burning ﬁre. Replace cracked or broken glass immediately. When reinstalling

the glass, be sure that the glass and gasket create a solid seal around door frame. Follow the instructions below

for glass removal. You may require a ﬂat tool to gently press the gasket between the glass and the door.

FIG.1

FIG.2

FIG.3

WARNING: DO NOT CLOSE DOOR FRAME ONCE DOOR GLASS HAS BEEN REMOVED AS THE

APPLIANCE HAS BEEN FITTED WITH BALANCE WEIGHTS. SEE "BALANCE WEIGHT ADJUSTMENT"

SECTION.