Instructions / Assembly

15
EN
www.napoleongrills.com
N415-0494 DEC 11.17

  
Low heat / Low ame
when valve turned to high.
For propane - improper lighng
procedure.
For natural gas - undersized
supply line.
For both gases - improper
preheang.
Ensure lighng procedure is followed
carefully. All gas grill valves must be
in the o posion when the tank valve
is turned on. Turn tank on slowly to
allow pressure to equalize. See lighng
instrucons.
Pipe must be sized according to
installaon code.
Preheat grill with both main burners on
high for 10 to 15 minutes.
Excessive are-ups/
uneven heat.
Sear plates installed incorrectly.
Improper preheang.
Excessive grease and ash build
on sear plates and in drip pan.
Ensure sear plates are installed with the
holes towards the front and the slots on
the boom. See assembly instrucons.
Preheat grill with both main burners on
high for 10 to 15 minutes.
Clean sear plates and drip pan regularly.
Do not line pan with aluminum foil. Refer
to cleaning instrucons.
Burners burn with yellow
ame, accompanied by
the smell of gas.
Possible spider web or other
debris, or improper air shuer
adjustment.
Thoroughly clean burner by removing.
See general maintenance instrucons.
Open air shuer slightly according to
combuson air adjustment instrucons.
(This must be done by a qualied gas
installer.)
Flames li away from
burner, accompanied
by the smell of gas, and
possibly dicules in
lighng.
Improper air shuer
adjustment.
Close air shuer slightly according to
combuson air adjustment instrucons.
(This must be done by a qualied gas
installer.)
Rear and Side burners will
not light with the igniter,
but will light with a match.
Dead baery / or installed
incorrectly.
Loose electrode wire or switch
terminal wires.
Liing ames on burner.
Replace with premium heavy duty
baery.
Check that electrode wire is rmly
pushed onto the terminal on the back
of the igniter. Check that the lead wires
from the module to the ignion switch (if
equipped) are rmly pushed onto their
respecve terminals.
Close air shuer slightly - see previous
problem.
Main burner will not light
with the igniter, but will
light with a match.
Jet-re outlet is dirty or
clogged.
Clean jet-re outlet with a so bristle
brush.