IR3GN Installation Guide

13
W415-1034 / A / 10.02.12
97.1
Remove the backing of the logo supplied and place on the glass viewing door,
as indicated.
½"
½"
LOGO
4.4 LOGO PLACEMENT
4.5 BATTERY INSTALLATION
4 AA batteries must be installed into the receiver before operation is
possible in the XIR3. The receiver is located in the bottom left corner
of the appliance.
NOTE: Ensure the 3 position
slider switch is in the "REMOTE"
position (middle position).
If receiver removal is necessary, remove the left access panel from the
front of the appliance. Remove the 2 screws holding the receiver in place.
Pull the receiver through the access hole and replace.
RECEIVER
RECEIVER
PLATE
SCREWS
(4) AA Batteries
ON REMOTE OFF