IR3GN Installation Guide

24
W415-1034 / A / 10.02.12
8.3 DOOR GLASS REPLACEMENT
A. Place the door frame face down careful not to scratch the
paint.
B. Center the gasketed glass inside the door frame with the thick
side of the gasket facing up.
C. Bend the glass retainers located along the edge of the door
frame over the gasket holding the glass in place. Careful not
to break the glass.
!
WARNING
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
APPLIANCE BEFORE OPERATION.
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
REMOVED, CRACKED, BROKEN OR SCRATCHED.
56.1A
NOTE: Care must be taken when removing and disposing of any broken glass or damaged
components. Be sure to vacuum up any broken glass from inside the appliance before operation.
GLASS
GASKET
DOOR
FRAME
GLASS
RETAINER
8.4 MEDIA TRAY INSTALLATION
Secure the media tray to the burner using 6 screws (W570-0001).
When removing the media tray make sure the glass media
is away from the center of the screen, exposing the burner,
remove screws and lift media tray out.
When replacing burner, absolutely no glass media can be
surrounding the orifi ce. HINT: If glass surrounds the orifi ce,
insert a clean bag into a vacuum cleaner and vacuum out
glass media. Replacement glass media can be ordered from
Wolf Steel Ltd.