User manual

13
INSTALLATION
If this appliance featuring magnetic door seals is to
replace an older appliance having a spring lock (latch) on
the door or lid, be sure to make that spring lock
unusable before you discard the old appliance. This will
prevent it from becoming a death-trap for a child.
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Best performance is obtained with
ambient temperature between +18°C and +43°C
(class T); +18°C and +38°C (class ST); +16°C and
+32°C (class N); +10°C and +32°C (class SN).
The class of your appliance is shown on its rating plate.
For building into kitchen units follow the special
“Building-in” instructions given.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably
sized auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
The Manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with EEC directive number
87/308 of 2/6/87 relative to radio interference
suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compa-tibility Directive) and subsequent
modifications.
Cleaning the interior
Before using the appliance for the first time, wash
the interior and all internal accessories with
lukewarm water and some neutral soap so as to
remove the typical smell of a brand-new product,
then dry thoroughly.
Do not use detergents or abrasive powders, as
these will damage the finish.
Changing the opening direction of the doors
The opening direction of the doors can be changed
on these appliances.
This must be done before the appliance is built into
the kitchen unit.
Top hinge
Using a
screwdriver,
remove the top
hinge and refit it
on the other side,
after having
removed the
covers which
mask the holes
provided for
fixing; use these
covers to mask
the holes left
open.
Bottom hinge
Remove the
bottom hinge (A)
and refit it on the
left-hand side of
bottom base of
the cabinet,
which has
pre-drilled holes
for fixing.
Centre hinge
After having
removed the top
and bottom hinges
(following the
instructions in the
previous
paragraphs),
remove the two
doors; unscrew the
two screws which
secure the centre
hinge to the
appliance cabinet;
turn the hinge upside down and fit it on the other
side of the cabinet, after having removed the covers
which mask the holes provided for fixing; use the
covers to mask the holes left open;
refit the two doors and tighten the top and bottom
hinges.
D120
D119
A
D121