User manual

Appliance door opening device (Fig. 5)

The accessories pack supplied with the appliance

contains a device to allow the kitchen unit and

appliance doors to be opened simultaneously.

Fig. 5

The device

consists of guide

(A), blocks (B),

securing screws

and block covers

(C).

To ﬁx guide (A),

drill the door as

shown in Fig. 4.

To ﬁt blocks (B), proceed as follows:

open the appliance and kitchen unit doors to about

90°; position block (B) on the inside of the unit door

as shown in Fig. 5; then secure it to the unit door,

positioning the screws at the far left-hand end of the

elongated holes in the block (Fig. 5); pressing

lightly, slide the block towards the left (the

elongated holes are provided for this purpose) until

the device engages on the guide, so allowing

simultaneous opening of both doors. After having

ﬁtted the bottom block (and engaging it on the

bottom guide) fully tighten the securing screws on

both blocks.

Fit the block covers (C) (Fig. 5); pressing them into

place.

The doors can be opened using the sliding system

previously illustrated, or one of the two doors can

be opened by ﬁtting the small handle supplied as an

accessory.

Fig. 5a

D118

D122