Users Manual Part 2

It takes 1-3 mins for room sectioning after mapping, please
wait.
Room sectioning, please
wait
Please do not operate the
robot during room sectioning
2015
Troubleshooting
Please put the robot on the ground to start.
Please clean the lidar if there is dirt on it.
Please use the robot after it is charged.
Please wait for the robot
to charge and continue
working.
Low power, please charge
the robot
The robot is picked-up,
please put the robot to a
new position to start.
The robot is picked-up
Please check the lidar Please check the lidar
3007
3008
3009
1. Please clean the hair and dirt on side brush by bird knife.
2. Replace the side brush if it is broken.
Side brush malfunction
Side brush malfunction,
please clean or replace the
brush module.
Please install dust bin Please install dust bin Please install the dust bin correctly and try again.
Please install the sweeping module before mapping.
Low power. The robot will continue to work after charging.
Please install the sweeping module/ mopping module.
1. Please empty the dust bin if it is full.
2. Please clean the lter and air vent if they are blocked.
3. Please air-dry the lter if it is still wet.
4. If the suction inlet is blocked, please clean it and try
again.
Please check dust bin, lter
and air vent
Please check dust bin
Please install the sweeping
module before mapping.
Please install sweeping
module or mopping module
before working.
Please install sweeping
module / mopping module
Please install the sweeping
module
Low power, the robot will
continue to work after
charging.
Low power, please wait
3001
3002
3003
3004
3005
3006
35
Error # Voice guide
Info on the base
station
How to solve the problem