User's Manual

ManualsBrandsNASACO Electronics ManualsAudio Equipment2.4 GHz WIRELESS HEADPHONE SYSTEM

Table Of Contents

2.4GHz Wireless Headphone

NTED800

REV0B Page 1 Of 10

July 02, 2005

Summary of content (10 pages)

PAGE 1
2.
PAGE 2
I. Location of Functions A. Transmitter(NTJD800) 1. 2. 3. 4. 5. 6. 7. 8. 9.
PAGE 3
B. Wireless Headphone(NTED800) 10. 11. 12. 13. 14. 15.
PAGE 4
Accessories: Audio Cable(Stereo) for Transmitter Adaptor(6V 500mA) for Transmitter Charging Cable(2.5mm + 3.
PAGE 5
Connecting the System I. Powering the Transmitter Connect the small, round plug from the transmitter AC power adaptor to the transmitter power input jack and plug the other end of the adaptor into any standard 120V AC wall outlet. Press the ON/OFF button of the transmitter. The Red LED on the power light should be ON. II. Connecting to an Audio Source Connect the audio cable to the LINE IN jack of the transmitter and plug the other end to audio source (e.g. LINE OUT of DVD player).
PAGE 6
Turn the LINE IN selection switch to LINE IN. The Audio/Video Switch is for latency select. Usually set at Audio for music listening.
PAGE 7
III. Powering the Headphone Open the Battery Compartment Cover of the headphone and insert 3 AAA-size batteries with proper polarity. Press ON/OFF button and green LED of POWER light should be flashing. Once the headphone is pair up with the transmitter, the green LED will remain ON. Turn volume to appropriate level and you can listen to the headphone. IV. Charging of batteries in headphone Insert the smaller plug of the charging cable into the charging jack of transmitter.
PAGE 8
Important – Charging of batteries This charging circuit will charge rechargeable NiMH or NiCd batteries. DO NOT attempt to charge any other batteries except those specified above Remember to charge the batteries overnight (or over 10 hours) for fully charge. Battery life for operation is about 5 hours. V. Audio Muting When audio source is cut off for 3 minutes, the speaker will be muted.
PAGE 9
REV0B Page 9 Of 10 July 02, 2005
PAGE 10
Nasaco NTED - 800 TESTED TO COMPLY WITH FCC STANDARDS FOR HOME OR OFFICE USE This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.