2.
I. Location of Functions A.Transmitter (NTJD800) 1. 2. 3. 4. 5. 6. 7. 8. 9.
B. Wireless Stereo Amplifier (NTM1700) 10. 11. 12. 13. 14. 15.
11 12 13 14 15 Rear view Accessories: Audio Cable (3.5mm to 3.
RCA to SPK Cable Y Cable (RCA to 3.5 Stereo Plug) Stereo Plug Adaptor (6.3 Plug to 3.
Adaptor (6V 500mA) for Transmitter EPA-241DAN-15 Adaptor (15V 1600mA) for Wireless stereo Amplifier, Or Adaptor (15V 800mA) for Wireless Stereo Amplifier Page 6 Of 15 Rev 00
Or UL Adapter (Input: 120, 60Hz; Output: 17V, 1.1A), for Wireless Stereo Amplifier, Part no.: HA57U-560 Or HA57VF-1711, (Input 230Vac 50Hz, 120mA, Output: 17Vdc, 1.
Connecting the System I. Powering the Transmitter Connect the small, round plug from the transmitter AC power adaptor to the transmitter power input jack and plug the other end of the adaptor into any standard 120V AC wall outlet.
Press the ON/OFF button of the transmitter. The Red LED on the power light should be ON. II. Connecting to an Audio Source Connect the audio cable to the LINE IN jack of the transmitter and plug the other end to audio source (e.g. LINE OUT of DVD player). Turn the LINE IN selection switch to LINE IN.
The Audio/Video Switch is for latency select. Usually set at Audio for music listening. III.
Insert bare wire part of speaker cables of to corresponding Left and Right Channel Output of the Wireless Amplifier. IV. Powering the Wireless Amplifier i. Turn the volume by rotating the volume control at the back of the unit to middle. ii. Insert the small, round plug from Wireless Amplifier AC power adaptor into the power input jack iii. Plug the other end of the AC power adaptor into any standard 120V AC wall outlet.
2. If transmitter is found and connected, the power/RSSI indicator will turn green. 3. Turn volume up at the back and you should hear sound coming from the speakers. Adjust the volume as desired. V. Audio Muting When audio source is cut off for 3 minutes, the Wireless Amplifier will be muted. But if audio signal resumes, the muting will be disabled and speaker will be ON again. VI. Active/Passive Receivers The 2.4GHz system can support infinite no.
receivers/speakers can maintain its performance and are independent with the no. of receivers in the system. If one “Active” receiver/speaker is powered off, the other “Passive” receivers/speakers cannot be jumped into Active Mode automatically. They have to be powered off first and then power up again to make it “Active”.
Page 14 Of 15 Rev 00
The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. Nasaco NTM-1700 TESTED TO COMPLY WITH FCC STANDARDS FOR HOME OR OFFICE USE This device complies with part 15 of the FCC rules.
