Installation Guide

Step 2‐Installation of Turf
• SWEEP and clean the area BEFORE YOU unroll the
grass & expose the grass face. Let the grass "relax" on
a flat, open area.
Once you relax the turf trim the EXTRA black edge off of
each edge of the turf (with a razor knife or carpet cutter)
so that the edges are very straight. Don't cut rows of
blades unless the edges seem uneven.
You may need to cut it the turf into smaller sections -
measure, each side - mark and cut. Use a chalk line, on
the back of the turf for long, straight cuts.
• Roll out the sections of turf on top of the prepared and
compacted base. Position the turf and pull out any
wrinkles, smooth and adjust the section, as needed.
• Lay each piece down, facing the GRAIN in the same
direction. It's best to FACE THE GRAIN TOWARDS the
VIEWER (to the street on a front yard - to the house in a
backyard). Setting the turf at odd angles to each other
will cause seams to show (if you are seaming sections)
• If you need to seam more than one piece, place them
together, and adjust to insure that the materials provide
100% cover to the project area. DO NOT CUT THE
OUTSIDE EDGE UNTIL YOUR SEAM IS COMPLETE!
(please view our seaming tips pages, for details)
Page 3\10
ARTIFICIAL GRASS INSTALLATION TIPS