Installation Guide

STEP 1: Prepare the turf & project area surfaces
• Measure the area you want to cover - take a measure of both width
and depth - SURFACE MATERIALS ARE 15 FEET wide,
Order materials: Some pre-cut products may be a different size -
MOST are 15 feet wide BY any length. Create a pattern if you require
more than one piece, by mapping out the sections on a piece of paper -
map each section of grass, facing in the same direction!
• PREP THE AREA - Remove any grass, sod, tree roots, mulch, rocks
and any debris and any "un-compactable" soils - to a depth of
approximately 3-4 inches.
• Install any curbing, edging, or other border materials
• ADD A LAYER OF WEED BARRIER FABRIC over the base layer -
secure with spikes or nails - over-lap sections (4 inch)
• Spread a 3” lift of base - best lift is achieved using a crush rock
material of ¾" + minus (crushed stone) - often referred to as road base
or AB. DG or ¼ minus is not advised for porous surface specifications
- tightly compacted, DG's permeability is reduced, over time.
• Grade the base as smoothly as possible using a 48" landscape rake
(flat side) or the flat side of a garden rake
• Lightly mist (dampen) the dry base surface with water - before
compacting. Do not "wet" the surface - simply dampen, to compact.
• Compact to about 80-90%. It is best to use a water roller for 3 to 4
inches of base (plate compacter is preferred over water roller, for base
over 4 inches. Compact the entire surface - brush out any ridges and
re-compact if needed - until smooth and at the height, desired.
ARTIFICIAL GRASS INSTALLATION TIPS
Page 2\10