User's Manual
Statement
This device complies with Industry Canada licence-exemptRSSstandard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference,and (2) this device must accept any interference,including interference that may cause undesired operation ofthe device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables auxappareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes :(1) l'appareil ne doit pas produire de brouillage,et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre lefonctionnement.
NOTE:
This equipment has been tested and found to comply with thelimits for aClass Bdigital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protectionagainst harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and usedin accordance with the instructions, may cause harmful
interference to radio communications.However, there is no guarantee that interference will not occurin a particular installation.If this equipment does cause
harmful interference to radio ortelevision reception, which can bedetermined by turning the equipment off and on, the user isencouraged to try to correct
theinterference by one or more of the following measures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and
receiver.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Consult the dealer or an experienced radio/TV
technician for help.
Compliance statement
1. This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received,including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user'sauthority to operate the equipment.
Warnings
Sound pressure: