Weather Radio User Manual

NOTE: If after 5 minutes the screen does not change to show the

outdoor temperature, remove all batteries for both units and

insert again, starting with the monitor.

5. Position the monitor and remote sensor within effective transmission

range, which in usual circumstances is 25 meters (82 feet). The range

is affected by the building materials and where the monitor and remote

sensor are positioned; try various locations for the best results.

NOTE: The remote sensor should be placed outdoors in a shaded area for

accurate readings.

Troubleshooting

If the outdoor temperature cannot be received, check:

1. The distance between the monitor or remote sensor should be at least

1.2 meters (4 feet) away from any interfering sources such as computer

monitors or TV sets.

2. Avoid placing the monitor onto or in the immediate proximity of metal

window frames.

3. Using other electrical products such as headphones or speakers

operating on the same frequency (433MHz) may prevent correct signal

transmission and reception.

4. Neighbors using electrical devices operating on the 433MHz signal

frequency can also cause interference.

5. Signals from other household devices, such as door bells and home

security systems, may temporarily interfere with the units and cause

reception failure. The transmission and reception of temperature reading

will resume once the interference has stopped.

The maximum transmission range is 25 meters (82 feet) from the remote

sensor to the monitor (in open space). However, this depends on the

surrounding environment and interference levels. The temperature signal

travels in a straight line from the remote sensor to the monitor. The signal

will not curve around an object. If no reception is possible, despite the

observation of these factors, all units will have to be reset.

Displaying Different Channels

If you have registered more than one remote sensor, press the CH button

on the monitor to select the outdoor sensor channel you want to display

permanently. To display each channel for 5 to 10 seconds on the monitor,