User manual

24
Figure 3.2. Multisim Oscilloscope Capture and Results for Amplifying Circuit
In Figure 3.2, the peak voltage read at Channel_A is the input voltage with a value of 98.125 mV. This value is not quite
the 100 mV peak you specified because Multisim takes into account a small voltage drop at the scope input. Also see
that Channel_B contains a peak voltage of 1.080 V. This represents the voltage at V Out. When you divide 1.080 V by
98.125 mV, you get 11.006. This is close to the gain of 11 that you previously calculated.
Next simulate an RC circuit to apply a lowpass filter to the output voltage. See Figure 3.3 for the layout of this circuit.