User manual

31
Figure 3.11. Configuring MSO Trigger Level
5. Turn on the DC power supply outputs by clicking the on/off button at the bottom of DC power supply segment.
Configure the -25 V supply to supply -5 V. Configure the +25 V supply to supply 5 V. Set the current outputs on
both supplies to 0.5 A.
Figure 3.12. Configuring DC Power Supply
6. Turn on the FGEN output by clicking the on/off button at the top of the FGEN segment. Set the output frequency
to 100 Hz. Set the amplitude to 0.2 Vpp and the DC offset to 0 V. Set the output waveform to be a sine wave.