User manual

47
Exercise 4.1: Using the MSO and DC Power Supply
1. Enable Channel 1 and Channel 2 in the MSO section by clicking the square icon next to the channel names.
Figure 4.7. MSO Probes Disabled (left) and Enabled (right)
2. Set DC power supply settings:
a. +6 V rail: 2 V
b. +25 V rail: 5 V
c. -25 V rail: 0 V
3. Enable the DC power supply by clicking the DC power supply power button on the VirtualBench application.
Figure 4.8. DC Power Supply Settings Enabled
4. Set FGEN settings:
a. Frequency: 10 Hz
b. Amplitude: 5 Vpp
c. DC offset: 2.5 V
d. Shape: Sine wave
5. Enable the FGEN by clicking the FGEN power button on the VirtualBench application.