Network Card User Manual

Chapter 2 Installation

Configuration Switch Settings for SW2

The DIP switch at location SW2 on the rear panel (see Figure 2-1) is used

to configure the mode of operation for the GPIB-SCSI-A. These switch

settings should not be changed for use with the Sun SPARC system.

Figure 2-3 shows the factory default settings. Make sure that these switches

are set as shown in Figure 2-3. If they are not, set these switches as

indicated.

Figure 2-3.

SW2 Default Mode Switch Settings

Table 2-3 shows the factory default configurations of the eight switches

for SW2.

Table 2-3. Factory Default Configurations for SW2

Switch Position Indication

1–3 OFF Reserved and should remain OFF

4 ON Double buffering is enabled

5 OFF GPIB-SCSI-A completes all data requests

to the count specified

6 ON GPIB-SCSI-A buffers data during data

transfer commands

7 ON GPIB-SCSI-A neither notices nor reports

SCSI parity errors

8 OFF Operating in S (SCSI) mode

SW2

12345678

9120

CTS 206-8

GS.book Page 5 Tuesday, June 12, 2001 2:17 PM