Network Card User Manual

Chapter 2 Installation
© National Instruments Corporation 2-7 GPIB-SCSI-A for Solaris
Figure 2-4 shows where to install terminating resistors if the GPIB-SCSI-A
is located at the end of a system.
Figure 2-4.
Location of Terminating Resistors for GPIB-SCSI-A at End of SCSI Bus
If your GPIB-SCSI-A is not located at the end of the SCSI bus, remove
the terminating resistor pack from the rear panel of the GPIB-SCSI-A. Also
ensure that all other devices in the middle of the bus (for example, the SCSI
disk drive in Figure 2-5) do not have terminating resistors installed. The
devices at each end of the SCSI bus should have terminating resistors
installed.
1 To GPIB Devices
2 Terminating Resistors
3 GPIB-SCSI-A
4 SCSI Tape Drive
5SCSIDiskDrive
6SCSIHost
P
O
W
E
R
R
E
A
D
Y
T
A
L
K
L
IS
T
E
N
S
E
N
D
R
E
C
E
IV
E
G
PIB
-S
CSI-A
I
E
E
E
-
4
8
8
S
C
S
I
C
O
N
T
R
O
L
L
E
R
1
2
3
4
5
6
GS.book Page 7 Tuesday, June 12, 2001 2:17 PM