Installation & Assembly

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Fierce™ Assembly Instruction
Required Tools
 5mm Hex Key (Included)
Package Contents Qty.
1
1
1
1
 Back assembly
 Plastic base
 Gas lift cylinder
 Seat assembly
 Hardware Kit:
- M6X14 hex head bolts
- M6X30 hex head bolts
- M8X30 hex head bolts
 Right arm assembly
 Left arm assembly
 Weight Balance Control
Mechanism
 Set of 5 casters
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 3216439
Rev, A
Printed in U.S.A
© 2020 Kimball International, Inc.
Product Line
Fierce™ Task Chair
1
Place mesh seat assembly upside down on an elevated flat surface.
Position the right and left arm assemblies on the bottom of the
seat as shown in Figure A. Note: To assure proper assembly of
the right and left arms, each arm should angle toward the front of
the seat, not rearward. Using the 5mm hex key wrench, secure each
arm with (3) M6 X 30 hex head bolts as shown in Figure A.
!
Assemble units as described herein only. All screws and bolts
must be tightened securely and checked periodically after
assembly. Failure to assemble or to secure parts properly may
result in assembly failure and personal injury.
Figure B
2
4
6
3
1
1
1
1
Figure A
3
Position control mechanism on bottom side of mesh seat assembly to
match the back 4-hole configuration. Using the 5mm hex key wrench,
secure the control mechanism to the seat assembly using (4) M6 X 14
hex head bolts as shown in Figure B.
Position the mesh back assembly to the corresponding hole
configuration on the back bottom of the control mechanism. Using the
5mm hex key wrench, secure the mesh back assembly with (3) M8 X 30
hex head bolts as shown in Figure C.
Figure C